This page describes the steps to successfully create and configure
Cross-Site Interconnect.

> [!NOTE]
> **Note:** For definitions of terms used on this page, see [Cloud Interconnect key
> terms](https://docs.cloud.google.com/network-connectivity/docs/interconnect/concepts/terminology).

To create and configure a Cloud Interconnect connection and create
a cross-site network, follow these steps:

1. [Check bandwidth quotas and limits](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/check-bandwidth-quota)

   Check your quota to ensure that you have enough bandwidth to support your
   expected traffic between metros. If you need more quota, you must request an increase
   before proceeding. Similarly, check the limit for the maximum bandwidth
   per wire and request an exception if necessary.
2. [Order Cross-Site Interconnect connections](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/order-connections)

   Submit an order, specifying the details of your connections.
   Google then emails you an order confirmation. After your resources have been
   allocated, you receive another email with your LOA-CFAs.
3. [Retrieve LOA-CFAs](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/retrieve-loas)

   Send the LOA-CFAs to your vendor. They provision the connections between
   the Google peering edge and your on-premises network. Google
   automatically starts testing the light levels on each allocated port after
   24 hours.
4. [Test the connections](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/test-connections)

   Follow the recommended steps to verify that your networks are connected
   to Google's network.
5. [Create a cross-site network](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/create-network)

   When your connections are ready to use, you need to connect
   your networks to each other. To do that,
   create a cross-site network over your connections, specifying the properties
   of the wire or wires between your networks, including their bandwidth.
6. [Configure on-premises routers](https://docs.cloud.google.com/network-connectivity/docs/interconnect/how-to/cross-site/configure-onprem-routers)

   After you create a cross-site network with one or more wire groups, to start
   sending traffic between your sites, you need to configure your on-premises
   routers to establish connectivity with each other.

If you have any issues during the provisioning steps, refer to the escalation
instructions provided in the LOA and the email that we sent to your technical
contact.